VSP-G1 Technical Specifications

Unit specifications possibly edit based on final design specs

Specification	Value
Mains supply voltage	110-240V AC
Mains frequency	50-60Hz
Power	175 V-A
Dimensions	Casing ca. 52x30x20cm Reactor added height ca. 10cm
Weight	19kg
Gas inlet/outlet	10mm tubes (with Swagelok connectors)
Display	16x2 characters
Digital output	RS232

Operating window

Parameter	Value
Flow rate	1-30 L/min
Gas	Supported: Ar or N2 (recommended purity 5.0) Unsupported: He, Ne, Xe, Kr Notification: Contact VSParticle for the use of reactive gases such as air and H2.
Electrode material	Comes with Cu electrodes. Various other metals (e.g. Ag, Au, Pt, W, Ni), semiconductors and carbon are possible.
Primary particle size	1 atom to 20 nm
Ablation rate	~0.01-100 mg/h (material dependent)
Typical particle concentration	108-1011 cm-3

External circuit terminals confirm text

Terminal	RS-232 (189.01-113)	HVout, HVret (A2J3, A2J4)
Description	Serial connector conform RS-232 specification, using only GND, Rx and Tx.	Coaxial connectors for high voltage connection to reactor. NOT FOR USE WITH EXTERNAL CIRCUITS. Instructions specify this. Terminal inactive if screw knobs not installed.
Connector	F-DE9 (sub-D, 9 pin) (RS 472-843)	189.00-155 (LEMO FAA.1S.405.CTA)
Rating/specification	RS-232	5kV / 21 mA d.c.
Voltage rating	Isolated 2.5kV	10.5kV d.c. (plug)
Current rating	-	8A d.c. (plug)
Other	UL1577	IP 5.0, 10.5mm creepage, PTFE insulation